Crystallised honey is honey in which part of the sugars has moved from the dissolved form into tiny crystals. The jar sets firm, the honey turns paler and a spoon goes into it only with effort. This is neither a fault nor a sign of poor quality — it is the state that every honey reaches by itself, sooner or later.
Why honey crystallises
Honey is a supersaturated sugar solution. In 100 g of honey there are only some 17 to 20 g of water, and dissolved in that water are around 70 to 80 g of sugars — far more than so little water would hold under ordinary circumstances. The solution is therefore unstable from the very beginning, and sooner or later part of the sugar comes back out of the water.
What settles the matter is the ratio of the two main sugars. Glucose (grape sugar) dissolves in water less readily, and it is glucose that drops out of the solution and arranges itself into crystals. Fructose (fruit sugar) is markedly more soluble and stays in solution. The more glucose a honey holds, the sooner it sets; the more fructose, the longer it stays runny.
The crystals also need something to start from. The seed is usually a grain of pollen, a speck of wax or an air bubble left in the honey after it was spun out of the combs. Honey that has only been coarsely strained therefore sets more willingly than honey filtered and warmed through to perfect clarity.
Why one honey sets in a month and another lasts a year
The ratio of glucose to fructose is not down to the beekeeper but to the plant the nectar came from. Hence the differences that anyone can see on their own shelf:
- Rapeseed, sunflower and dandelion honey have the most glucose and can firm up within a few weeks of being spun out. With rapeseed it is often so quick that it goes into the jars practically setting already.
- Blossom honeys from a mixed flow sit somewhere in between — they usually stay runny for months, not years.
- Acacia honey, on the other hand, has fructose to spare and stays liquid for a year or even two.
- Honeydew (forest) honey mostly sets slowly. The exception is honeydew with a higher melezitose content, which sets very quickly and very hard indeed — beekeepers call it cement honey.
Besides composition, the storage temperature has its say. Honey crystallises fastest at round about 14 °C; in warmth above 25 °C the process is slower, and in real cold it is slower as well, because the honey thickens and the molecules move about lazily in it. A cool larder or hallway is thus, as it happens, roughly the most crystallisation-friendly spot in the house. That is why the label asks for room temperature: in the cold the honey sets sooner, but nothing else happens to it — crystallisation is not spoiling. Crystallisation can be slowed down, not switched off.
Creamed honey: crystallisation the beekeeper brings on deliberately
If crystallisation cannot be prevented, it can at least be steered. That is precisely what creaming is: at the point when the honey begins to set, it is stirred again and again, so that the crystals forming in it are broken down as they go into microscopically small ones. The result is a honey that is firm, true, but smooth and spreadable like butter instead of coarsely gritty. It is not an additive and not a change to the composition, only mechanical work with what honey does of its own accord. In our range it is the ANIMAL - complementary feed for dogs and cats 200 g that is built on creamed honey; the products for people use quality honey from South Bohemia.
What crystallisation means for SUPRAMEDEX products
The honey in our honey-based products is not a flavouring but the main ingredient: in EXTRA in honey 900 g it makes up 95 g out of every 100 g, the rest being the extracts the recipe calls for. The jar therefore behaves like honey — in time it firms up, turns paler and is harder to spoon out.
Crystallisation is a physical change of state in the sugars, not a change of composition. A set jar holds exactly what was poured into it, and the product is still perfectly usable. Anyone who is fond of the runny form can bring it back with a water bath.
What you need for melting it in a water bath
- the jar with the crystallised product
- a larger pan for heating the water
- warm water for the water bath
- a kitchen thermometer to check the temperature of the water bath
- a clean, dry spoon for stirring
How to go about it
Get the pan of water ready: Pour in enough water for it to surround the jar, but not so much that it spills over or lifts the jar off the bottom.
Warm the water: Warm the water to a mild temperature, no more than 40 °C. Never bring the water to the boil or heat it anywhere near boiling point. The surest way is to heat the water, take the pan off the hob and only then put the jar in.
Lower the jar in: Place the jar with the product into the pan of warm water. If the jar is closed, open it, so that the heat passes in more easily.
Stir it: Stir the contents of the jar now and then, to spread the heat evenly and speed up the melting of the crystals. Without stirring, only the layer against the walls warms up.
Keep checking the temperature: Use the thermometer on the water and on the product alike. Do not go above 40 °C.
Wait until the product is liquid again: Depending on the quantity and on how hard the crystals are, it can take anything from a few minutes to several hours for the product to dissolve completely. The only way of hurrying it along is to raise the temperature — and that is exactly what must not be done.
Why honey must not be overheated
The 40 °C limit is not caution for its own sake; there are measurable changes behind it. Heat lowers the activity of the honey’s own enzymes, diastase and invertase for instance, and at the same time raises the content of hydroxymethylfurfural (HMF) — a substance that builds up in honey through the action of heat and time. Both of these can be measured in a laboratory, and it is by them that overheated or old honey is told apart; an upper limit for HMF is laid down in the European rules for honey as well. On top of that, volatile aromatic substances evaporate out of honey, so overheated honey loses its scent and its flavour flattens into ordinary sweetness. The same 40 °C limit is therefore on our labels too, for dissolving in tea.
A microwave oven is the worst possible choice. It does not heat evenly but in the spots it happens to reach, and before the contents of the jar are stirred through, part of the honey can be locally well above 40 °C while the rest is still solid. No thermometer will keep that in check. The same goes for heating directly on the hob, where the honey bakes onto the bottom of the vessel.
How to put crystallisation off
- Take it out with a clean, dry spoon only. Honey is hygroscopic and will happily soak up moisture from the air, or a stray drop of water. A higher water content does slow crystallisation down, but it also opens the door to osmotolerant yeasts, after which the honey starts to ferment and froth. A dry spoon therefore matters more than anything else on this list.
- Close the jar once you have taken some out.
- Keep it somewhere dry and dark at room temperature, as it says on the label. A fridge is not needed.
- Use it up within four months of opening. The date of opening written on the lid with a marker pen saves guesswork later on.
- Do not melt it over and over again. Every warming takes a little of honey’s aroma away, so a water bath makes sense once, not every week.
Crystallised honey, then, is nothing that needs rescuing. Firm or runny, it is one and the same honey with one and the same composition — the only difference is whether its sugars are dissolved in water or lined up in crystals.